SIBCO

The thrust ball bearing adopts a design that can accept thrust loads during high-speed operation, and is composed of a washer shaped ring with a rolling groove for the ball. Due to the cushion shaped ring, thrust ball bearings are divided into two types: flat bottomed cushion type and self-aligning spherical cushion type. In addition, this type of bearing can accept axial loads, but cannot accept radial loads.

Composition of thrust ball bearing: The thrust ball bearing consists of three parts: the seat ring, the shaft ring, and the steel ball holder assembly. The shaft ring that matches with the shaft and the ring that matches with the housing are divided into one-way thrust ball bearings and two-way thrust ball bearings according to the force conditions. The thrust ball bearings can accept one-way axial loads. Bidirectional thrust ball bearings can accept bidirectional axial loads, where the shaft ring is matched with the shaft.

The device surface of the seat ring is a spherical bearing with self-aligning performance, which can reduce the impact of device errors. Thrust ball bearings cannot accept radial loads and have a low speed limit. There are two types of thrust ball bearings available: unidirectional and bidirectional. In order to allow for device errors, both unidirectional and bidirectional thrust ball bearings can choose spherical self-aligning spherical cushion type or ball seat ring type.

High quality steel - using ultra clean steel that can extend the life of bearings by 80% Highly advanced smoothing grease technology - NSK's smoothing agent technology can extend the life of smoothing grease and improve the performance of bearings High grade steel ball - quiet and smooth when rotating at high speed The collar in the application options may allow for device errors.

The purpose of editing thrust ball bearings is only applicable to parts that accept axial loads on one side and have low rotational speeds, such as crane hooks, vertical water pumps, vertical centrifuges, jacks, low-speed reducers, etc. The shaft ring, seat ring, and rolling element of the bearing are separate and can be installed and removed separately.